JUKI DDL-8700A-7 Instruction Manual page 37

8 Selection of the optional input/output function (Function setting No. 12)
1 2
A
3 4
i 0 1 *
i 1 7
o 0 1 *
o 0 3
* Example) to assign the thread trimming function to the input function setting connector indication number "i01" (cN36-4)
1 2 o P
o
P t _ i n
i 0 1 n
i 0 1 t
L
i 0 1 L
H
i 0 2 S F
o P t _ i n
o _ E
P t _
7
5
6
[When "in" is selected]
The nput functon settng connector ndcaton number s shown on ndcat-
* *
ng secton A . Desgnate the ndcaton number by means of key 3 or 4 .
Specfy the functon of the pn of the connector correspondng to the ndca-
ton number by means of key 5 or 6 .
Functon code and abbrevaton are dsplayed alternately on ndcator B .
(For the relaton between sgnal nput No. and connector pn array, refer to
the separate lst.)
[When "out" is selected]
* * The output functon settng connector ndcaton number s shown on nd-
catng secton A . Desgnate the ndcaton number by means of key 3 or 4 .
Specfy the functon of the pn of the connector correspondng to the ndca-
ton number by means of key 5 or 6 .
Functon code and abbrevaton are dsplayed alternately on ndcator B .
(Refer to the separate table for the relaton between the sgnal output num-
bers and the connector pin configuration.)
t _
. Select functon settng No. 2 wth the operatng procedure of functon
settng procedures ) through 3).
_ _
2. Select the tem of "n" wth keys 5 and 6 .
o P 3. Select the port of the ndcaton number "0" by means of key 4 .
S W
4. Select the thread trmmng functon, "TSW" wth keys 5 and 6 .
Lighting alternately
4
5. Determne the thread trmmng functon, "TSW" wth key 4 .
4
6. Set ACTIVE of the sgnal wth keys 5 and 6 .
Set the dsplay to "L" when the sgnal s "Low" and performng thread
trmmng, and set the dsplay to "H" when the sgnal s "Hgh" and per-
4
formng thread trmmng.
S W
7. Determne the aforementoned functon wth key 4 .
_ _ 8. Fnsh the optonal nput wth key 4 .
n d
9. Select the tem of "End" wth keys 5 and 6 to return to the functon set-
tng mode.
1 2 o
Select functon settng No. 2 wth the operatng pro-
cedure of functon settng procedures ) through 3).
B
o _
P t _
i
o
Select the tems of "End", "n" and "ouT" wth keys 5
and 6 .
– 34 –
P t _
E n d
n _ _
u t _