Setting Of The Auto Lifter Function; Connection Of The Material End Sensor (Ed) - JUKI DDL-8700 Instruction Manual

9. Setting of the auto lifter function

6
5
(Caution) 1. To perform re-turning ON of the power, be sure to perform after the time of one second
or more has passed.
(If ON / OFF operation of the power is performed quickly, setting may be not changed
over well.)
2. Auto-lifter is not actuated unless this function is properly selected.
3. When "FL ON" is selected without installing the auto-lifter device, starting is
momentarily delayed at the start of sewing. In addition, be sure to select "FL OFF"
when the auto-lifter is not installed since the touch-back switch may not work.

10. Connection of the material end sensor (ED)

2
3
1
When the auto-lifter device (AK) is attached, this
function makes the function of auto-lifter work.
1) Turn ON the power switch while pressing switch
3 inside the control box.
2) LED display is turned to 5, 6 (FL ON) with "beep",
and the function of auto-lifter becomes effective.
3) Turn OFF the power switch, and turn ON the power
switch again to return to the normal mode.
4) Repeat the operation 1) to 3), and LED display is
turned to (FL OFF). Then, the function of auto-lifter
does not work.
FL ON : Auto-lifter device becomes effective.
FL OFF : Auto-lifter function does not work.
(Standard at the time of delivery)
(Similarly, the presser foot is not automatically lifted
when programmed stitching is completed.)
1) Connect the connector of material end sensor (ED)
to connector 1(CN55 : 6P) of SC-500.
2) Tighten the cord of the material end sensor together
with other cords with cable clip band 2 attached
to the side of the box after passing it through the
cable clamp.
(Caution)
1. Be sure to turn OFF the power before
connecting the connector.
2. For the use of the material end sensor, refer
to the Instruction Manual attached to the
material end sensor.
33