Table of Contents
Advertisement
SETUP SHEET
Description
The media width can be sensed automatically for opaque media, but not for transparent media.
This means that the width and mounted location of the media must be set manually. Incorrect settings may cause ink
to be applied at locations where no media is present.
SHEET POS.
CANCEL
Note that to keep the heads from drying out, the [SHEET POS.] menu ends automatically after a certain interval, even
if you're still making settings there.
The settings for the media width and start position made here are effective only when [SHEET TYPE] is set to "CLEAR."
Selecting "OPAQUE" disables the settings, although the setting values are saved in memory. Choosing "CLEAR" again
enables the values set previously.
Default Setting
[SHEET TYPE]: OPAQUE
[SHEET WIDTH]: 2641 mm
Use
After positioning, close the front cover.
Press
Press
Press
To quit making settings at the [SHEET POS.] menu, use
close the front cover and press
4-5 Accommodating Various Kinds of Media
to move the heads.
Align this surface with the edge of the media.
to enable the setting.
.
to go back to the original screen.
.
to select "CANCEL," then
Chapter 4 Feature Reference
89
Advertisement
Table of Contents
