Table of Contents
Advertisement
The media has jammed.
Carefully remove the jammed media. The print heads may
also be damaged. Perform head cleaning, then perform a
printing test and check the results.
The media was pulled with excessive force.
Excessive tension was applied to the media, and additional
action is necessary to recover from this state. First, move
the loading lever to the rear and open the cover for the feed
and take-up units. Adjust the media to create a small amount
of slack, then switch on the sub power.
[NO MAINTENANCE LIQUID]
The maintenance liquid cartridge is empty.
Press
to clear the error message. Execute the printer's
[MAINTE. LIQUID] menu item and replace the maintenance
liquid cartridge with a new one. If the machine is allowed
to stand with the error uncorrected, the print heads may
dry out and become damaged.
p 70 "Replacing the Maintenance Liquid Cartridge"
[PINCHROLL ERROR LOWER PINCHROLL]
was pressed without first lowering the pinch
rollers.
Press any key to clear the error. Pull back the loading lever,
then press
.
The pinch rollers were raised while
minated.
The error is cleared automatically after a short wait. Never
move the loading lever while printing is in progress.
[SERVICE CALL xxxx]
An unrecoverable error occurred, or part replace-
ment that must be performed by a service techni-
cian is required.
Note the number displayed, then switch off the sub power.
After you switch off the power, inform your authorized
Roland DG Corp. dealer of the number that appeared on
the display.
[SHEET SET ERROR SET AGAIN]
was pressed even though no media is loaded.
Press any key to clear the error. Load media and pull back
the loading lever, then press
Transparent media was loaded even though [SHEET
TYPE] is set to "OPAQUE."
Press any key to clear the error. Set the [SHEET TYPE] menu
item to "CLEAR," then reload the media.
p 88 "Using Transparent Media"
was illu-
.
5-8 If an Error Message Appears
The positioning of the loaded media is displaced to
the left.
Press any key to clear the error. Reload the media at the
correct position, then press
The platen is dirty.
Press any key to clear the error. The machine cannot sense
the width of the media because of soiling. Clean the platen.
[TEMPERATURE IS TOO HIGH]
The temperature of the location where the machine
is installed has risen above the ambient tempera-
ture at which the machine can operate.
Operation cannot be continued. Switch off the sub power.
Bring the installed location to a temperature at which op-
eration is possible (20 to 32˚C) and allow the machine to
come to room temperature, then turn on the power.
[TEMPERATURE IS TOO LOW]
The temperature of the location where the machine
is installed has fallen below the ambient tempera-
ture at which the machine can operate.
Operation cannot be continued. Switch off the sub power.
Bring the installed location to a temperature at which op-
eration is possible (20 to 32˚C) and allow the machine to
come to room temperature, then turn on the power.
[WRONG CARTRIDGE]
A cartridge that cannot be used was installed.
Remove the cartridge to clear the error. Use a cartridge of
the specified type.
[WRONG WIDTH UNDER 1220mm (or 48")]
The width of the loaded media is too narrow.
Press
to clear the error. Note, however, that perform-
ing printing without making any changes causes the media
to be fed incorrectly, which may result in malfunction or
damage to the machine. Replace with media of usable size.
Chapter 5 What to Do If
.
117
Advertisement
Table of Contents
