Table of Contents
Advertisement
2-2 Loading and Cutting Off Media
1.
Mount the media and the paper pipe on the roll shaft.
Load the media onto the roll shaft.
Press in to fit on securely.
Hexagonal
wrench (large)
End cap
Place this surface against
the media.
For a media width of 2,500 mm
34
Chapter 2 Operation
Roll media
Be careful to orient correctly when loading.
Media having an outward curl
Printed surface
Media having an outward curl
Printed surface
Spacer
Bearing
Press in to fit on securely.
Reinforcement pipe
(for media having a width of
1,800 mm [74 inch] or more)
Align the distance between the bearing and the edge
of the media.
* The media gauge has a scale indicating media width.
Place the end of the media gauge against the edge of the
media and align the end face of the bearing with the
scale mark for the media width you're using.
Hexagonal
wrench (large)
End cap
Roll shaft
Bearing
Media gauge
Advertisement
Table of Contents
