Table of Contents
Advertisement
Mount the roll shaft in the paper pipe.
Press in to fit on securely.
Hexagonal
wrench (large)
End cap
Adjust the positioning of the end cap
to a value of 100 mm (4 in.).
* The scale on the media gauge is useful
for adjusting the positioning. Each scale
tick corresponds to 10 mm.
Never overly loosen the screws for the end caps.
When an end cap screw is loosened completely, it stops
turning. Never apply more force beyond that point. At-
tempting to turn the screw with undue force may dam-
age the component securing the screw, making return
to the original state impossible.
Paper pipe
Spacer
Roll shaft
2-2 Loading and Cutting Off Media
Press in to fit on securely.
100 mm
Bearing
Chapter 2 Operation
Hexagonal
wrench (large)
End cap
35
Advertisement
Table of Contents
