Electrical Wiring; Wiring Inspection - Dinli DL-801 Service Manual

ELECTRICAL SYSTEM

Electrical Wiring

Wiring Inspection

● Visually inspect the wiring for signs of burning, fraying,
etc.
If any wiring is poor, replace the damaged wiring.
★
● Pull each connector [A] apart and inspect it for corrosion,
dirt, and damage.
If the connector is corroded or dirty, clean it carefully. If it
★
is damaged, replace it.
● Check the wiring for continuity.
○ Use the wiring diagram to find the ends of the lead which
is suspected of being a problem.
○ Connect the hand tester between the ends of the leads.
○ Set the tester to the x 1 Ω range, and read the tester.
If the tester does not read 0
★
Replace the lead or the wiring harness [B] if necessary.
Battery Removal
● Disconnect the battery negative (-) cable [Black] first and
then the positive (+) cable [red].
● Take out the battery.
Battery Installation
● Connect the positive cable first and then the negative
cable.
Ω the lead is defective.
【7-6】