Dinli DL-801 Service Manual page 90

ENGINE
● Remove balance shaft from the left crankcase.
● Clean off all gasket material from the crankcase mating
surfaces.
NOTE:
Avoid damaging the crankcase mating surfaces.
● Inspect the balance shaft gear teeth.
Burrs/chips/roughness/wear – Replace.
CRANKSHAFT INSPECTION
● Inspect the crankshaft gear teeth.
Burrs/chips/roughness/wear _ Replace.
● Measure the connecting rod small end I.D.
Service Limit: ψ17.05 mm replace if over
【6-35】