BRAKE
Disc Cleaning
Poor braking can be caused by oil on a disc. Oil on a disc
must be cleaned off with an oil cleaning fluid such as
trichloroethylene or acetone.
WARNING
△
These cleaning fluids are usually highly flammable and
harmful if breathed for prolonged periods. Be sure to
heed the fluid manufacturer's warnings.
Disc Removal
●Remove:
Front Hub (see Wheels/Tires chapter)
Brake Disc Mounting Bolts [A]
Brake Disc [B]
Disc Installation
●The disc must be installed with the marked side [A] facing
toward the steering knuckle.
●Tighten:
Non-permanent Locking Agent - Disc Mounting Bolts
Torque - Disc Mounting Bolts: 37N-m(3.8kg-m,27ft-lb)
●After installing the discs, check the disc runout. Completely
clean off any grease that has gotten on either side of the
disc with a high flash point solvent.
Disc Wear Inspection
●Measure the thickness of each disc at the point [A] where it
has worn the most.
★ Replace the disc if has worn past the service limit.
[B] Measuring Area
Disc Thickness
Standard:
Service Limit:
3.5mm
3mm
【3-8】