Table of Contents
Advertisement
Disc Runout
●Jack up the vehicle so that the wheels are off the ground.
●Remove the front wheels and turn the handlebar fully to
one side.
●Set up a dial gauge against the disc [A], and measure the
disc runout.
If the runout exceeds the service limit, replace the disc.
★
Disc Runout
Standard:
Service Limit:
Brake Hose Inspection
●The high pressure inside the brake line can cause fluid to
leak or the hose to burst if the line is not properly
maintained. Bend and twist the brake hose while examining
it.
Replace it if any cracks or bul
★
Brake Hose Replacement
●Pump the brake fluid out of the line as explained in the
Brake Fluid Change.
●Remove the banjo bolts at both ends of the brake hose, and
pull the hose off the vehicle.
●Immediately wipe up any brake fluid that spills.
CAUTION
Brake fluid quickly ruins painted surfaces; any spilled fluid
should be completely washed away immediately.
●Use a new flat washer for each side of the hose fittings.
●Install the new brake hose in its place, and tighten the banjo
bolts.
Torque - Brake Hose Banjo Bolts: 25N-m(2.5kg-m,18.0ft-lb)
TIR 0.2 mm or less
TIR 0.3 mm
ges are noticed.
【3-9】
BRAKE
Advertisement
Chapters
Table of Contents
