Dinli DL-801 Service Manual page 87

ENGINE
PRIMARY DRIVE AXLE REMOVAL
● Remove the clutch/driven pulley. (Refer to "DRIVE AND
DRIVEN PULLEYS")
● Remove the oil seal and cir-clip.
● Remove the primary drive axle.
● Inspect the bearings for allow play in the transmission case
cover or the bearing turns roughly.
If any defects are found, replace the bearing with a new one.
INSTALLATION
Reverse the "TRANSMISSION REMOVAL" procedure to
install the primary drive axle, the counter axle, the main axle,
the shift cam, the shift fork, guide bar and shift shaft.
NOTE:
Make sure that the lever on the gear change switch correctly
engages with the locating slot on the shift shaft. Align the mark
on the shift shaft gear with the mark on the shift cam gear.
● Fill the engine oil and transmission oil.
【6-32】