Table of Contents
Advertisement
SUSPENSION/STEERING
Handlebar Removal
●Remove:
Throttle Switch (see Steering Stem Removal)
Front Brake Master Cylinder
Left-hand Switch Housing
Handlebar Cover Screw
Handlebar Cover
●Remove:
Handlebar Holder Bolts [A]
Handlebar Holders [B]
Handlebar [C]
Handlebar Installation
●Install the handlebar so that the angle of the handlebar
matches the angle of the steering stem as shown.
●Tighten the holder rear bolts first [A] and then the front
bolts [B].
Torque –
Handlebar Holder Bolts: 27 N-m (2.8 kgf-m, 20 ft-lb)
○If the holder is correctly installed, there will be no gap at
the rear and an even gap at the front after tightening.
【4-10】
Advertisement
Chapters
Table of Contents
