Rear Brake Pads Removal - Dinli DL-801 Service Manual

BRAKE

Rear Brake Pads Removal

●Remove the caliper (see Caliper Removal)
●Remove the Cir-clip [A] and bolt [B]
●Remove:
Anti-rattle Spring [C]
Brake Pads [D]
Brake Pad Installation
●Check the lining thickness (see Brake Pad Wear
Inspection).
●Push the caliper piston in by hand as far as it will go.
●Be sure that the anti-rattle spring is in place.
●Install the pads.
○Be careful not mix it up inboard pads with the out board
pad.
●Tighten:
Torque - Pad Mounting Bolts:18N-m(1.8kg.m,13.0ft.lb)
WARNING
△
Do not attempt to drive the vehicle until a full brake level
is obtained by pumping the brake level until the pads are
against each disc. The brakes will not function on the first
application of the level if this is not done.
【3-12】