BRAKE
Brake Disc Removal
●Remove the rear caliper, unscrew the banjo bolt and
remove the brake hose from the caliper.
●Loose the brake disc mounting bolts [A] and nut [B].
●Support the vehicle.
●Remove the rear wheel (see Wheel Removal).
●Remove the disc.
Brake Disc Installation
●The disc must be installed with the marked side [A] facing
toward the steering knuckle.
●Tighten:
Non-permanent Locking Agent - Disc Mounting Bolts
Torque - Disc Mounting Bolts:37N-m(3.8kg-m,27ft-lb)
●After installing the discs, check the disc runout (see Disc
Runout). Completely clean off any grease that has gotten on
either side of the disc with a high flash point solvent.
●Check the disc wear (see Disc Wear).
【3-14】