Rear Shock Absorber Preload Adjustment
●See the Front Shock Absorber Preload Adjustment
Suspension Arm Removal
●Remove:
Front Wheel (see Wheels/Tires chapter)
Front Hub (see Wheels/Tires chapter)
Cotter Pin, Nut and Bolt [A]
Tie-Rod End [B]
Front Shock Absorber Mounting Bolts [C]
Suspension Arm Pivot Bolts [D]
Suspension Arm Installation
●Tighten:
Torque –
Suspension Arm Pivot Bolts: 88 N-m (9.0 kgf-m, 65 ft-lb)
Steering Knuckle Joint Nut: 42 N-m (4.3 kgf-m, 31 ft-lb)
Suspension Arm Disassembly
●Tighten:
Collar [A]
Bearing Collar [B]
Seal Cover [C]
●Holding the suspension arm with a vise, remove the cir-clip
[D] and unscrew the knuckle joint [E].
CAUTION
Do not remove the knuckle joint grease seal. It is packed
with grease.
SUSPENSION/STEERING
【4-3】