Ignition Coil Installation; Ignition Coil Inspection - Dinli DL-801 Service Manual

ELECTRICAL SYSTEM

Ignition Coil Installation

● Connect the primary winding leads to the ignition coil
terminals

Ignition Coil Inspection

● Remove the ignition coil.
● Measure the primary winding resistance as follows:
○ Connect the tester between the coil terminals.
○ Set the tester to the × 1Ω range, and read the tester.
● Measure the secondary winding resistance as follows:
○ Remove the plug cap by turning it counterclockwise.
○ Connect the tester between the spark plug lead and
terminal.
○ Set the tester to the × 1 kΩ range, and read the tester.
If the hand tester does not read as specified, replace the
★
coil.
○ To install the plug cap, turn it clockwise.
【7-12】