English
7.
Water level control of boiler
The machine is fitted with a series of automatic level control
devices to keep the water in the boiler at a pre-set level.
The indicator light (4) comes on when water enters the boiler.
8.
Rinsing
Before operating the machine, perform a rinse of
! ! ! ! !
the internal circuits and change the water in the
! ! ! ! !
boiler."
8.1 Changing the water in the internal groups circuits
Remove the filter carriers (21, 25) of the distributor groups.
Via the continuous distribution key (30), empty the water from
each group for approximately one minute. Repeat this
operation twice.
8.2 Changing the water in the boiler
Ensure that the indication on the display corresponds to the
working pressure value.
Keep the hot water distributor key (13a - 13c) pressed down
for approximately 5 seconds.
The following message will be displayed: "water change",
followed by an audio signal. The water from the boiler will
drain from the hot water nozzle (10).
All the other keys will be deactivated.
9.
Cleaning
Cleaning the cappuccino maker
This operation must be made at the end of each working day.
1. Fill a container with 0,5 litre of cold water and one dose of
liquid detergent (see product instructions).
2. Remove the suction (18d) tube from the milk container and
immerse it in the solution.
3. Press button (16) and repeat the operation until all the
detergent has been used up.
4. Disassemble the cappuccino maker (18):
Unscrew the knob (18b) and remove the cappuccino
maker (18).
Remove the cover.
Unscrew the ring nut of the knob (18b) and remove it.
Unscrew and remove the adjustment screw (18a).
Prepare another dose of detergent and clean each piece.
Remove any residue with a sponge.
Reassemble the cappuccino maker.
5. Rinse, pumping out at least one litre of cold water.
Filling the boiler with water using the manual service tap
This function should be used only if the electronic level control
devices are not working correctly.
Push the manual boiler water fill lever (22), taking care not to
exceed the MAX level on the optic indicator (19).
21/25
When only steam is issued from the nozzle (10), press the
hot water stop key (13b).
The machine will return to its normal functions and the boiler
will be refilled with water.
16
18a
18b
18d
55
English
13a
13b
13c
10
30
18