Drinks Distribution - Cappuccino; Cappuccino Maker Instruction - Faema E92 Manual

English
6.3 Drinks distribution - cappuccino (only if the cappuccino function is active)
Use only the filter carrier (21) with a one-way spout and
the distribution group to the left.
After having removed the filter carrier (21) from the group and
emptied it of the previous grounds, fill with a new dose of
ground coffee and press.
Insert the filter carrier into the group, locking it well in place.
Place the cappuccino maker (18) close to the filter carrier
spout (21).
Position the cappuccino cup, or a suitable container in such
a way so that the coffee and milk can flow into the cup without
having to move it between the two flows.
Press one of the cappuccino distribution keys (26, 27, 28 or
29). The led above the selected key lights up, distribution
commences and then stops automatically.
It is possible to stop the distribution at any time by pressing
the continuous/STOP key (30).
As described in Chapter "Programming the cappuccino
distribution keys", it is possible to select whether to distribute
first the milk and then the coffee or vice versa.
Paragraph, "User Instructions for the Cappuccino Maker"
describes how to adjust the temperature of the milk and the
density of the milk froth.
"When the machine is not used for a long period of
! ! ! ! !
time, comply with the hygiene procedures regarding
preservation of milk".
6.4

Cappuccino maker instruction

Insert the tube (18d) into the milk.
Place a container under the cappuccino maker (18).
Remove the knob (18b) to facilitate the circulation of air.
Completely rotate the air adjustment screw (18a) clockwise,
then turn it back by half a turn.
Completely rotate the temperature adjustment screw (18c)
clockwise, then turn it back by half a turn.
At this point, press the required key to obtain milk or
cappuccino.
Adjustment of the cappuccino froth
Too much froth:
Finely rotate the air adjustment screw (18a) clockwise.
Too little froth:
Finely rotate the air adjustment screw (18a) anticlockwise.
Cappuccino temperature
If the cappuccino is too hot:
Finely rotate the temperature adjustment screw (18c)
anticlockwise.
If the cappuccino is not hot enough:
Finely rotate the temperature adjustment screw (18c
clockwise.
Distribution of hot unwhipped milk
Press and completely push in the knob (18b), then press the
desired milk or cappuccino distribution key.
26
18a
18b
18c
18d
53
27 30 28 29
18 21
18
English