Paprwidth Mismatch; Paper Size Not Detected - Canon imagePROGRAF iPF765 User Manual

PaprWidth Mismatch

PaprWidth Mismatch
PaprWidth Mismatch
When Detect Mismatch in the Control Panel menu is set to
Pause or Warning, the width of the loaded roll does not
match the width specified in Fit Roll Paper Width in the
printer driver.

Paper size not detected.

Paper size not detected.
Paper has been loaded askew, or warped paper has been loaded.
628
Because the Platen is soiled with ink or other substances, the size
of the clear film cannot be detected.
Cause
Cause
Corrective Action
Press ▲ or ▼ to select Print, and then press the OK button to resume
printing.
However, note that this error may cause paper jams and affect the printing
quality.
Press ▲ or ▼ to select Stop Printing, and then press the OK button.
Follow these steps to replace the roll to match the width specified in the
printer driver.
1.
Press ▲ or ▼ to select Change Paper, and then press the OK button.
(See "Removing the Roll from the Printer.")
(See "Removing the Roll Holder from Rolls.")
2.
Replace the paper with paper compatible for borderless printing.
(See "Attaching the Roll Holder to Rolls.")
(See "Loading Rolls in the Printer.")
The printer now starts printing the print job.
Make sure the roll width selected in the dialog box displayed when you se-
lect Fit Roll Paper Width in the printer driver matches the width of the roll
loaded in the printer, and then try printing again.
Follow these steps to reload the roll.
1.
Push the Release Lever back.
2.
Adjust the right edge of the roll to make it parallel to the orange
Paper Alignment Line.
3.
Pull the Release Lever forward.
4.
If "Not finished printing. Finish printing remaining jobs?" is
shown on the Display Screen, press the OK button.
Printing will resume, starting from the page on which the error
occurred.
(See "Loading Rolls in the Printer.")
If this error recurs after you reload the roll, remove the Roll Holder
from the printer, push the roll firmly in until it touches the Roll Holder
flange, and reload the Roll Holder in the printer.
(See "Attaching the Roll Holder to Rolls.")
Follow these step to reload a sheet.
1.
Push the Release Lever back.
2.
Load the sheet, aligning it with the guide on the right.
3.
Pull the Release Lever forward.
4.
If "Not finished printing. Finish printing remaining jobs?" is
shown on the Display Screen, press the OK button.
Printing will resume, starting from the page on which the error
occurred.
(See "Loading Sheets in the Printer.")
Open the Top Cover and clean the entire Platen.
(See "Cleaning Inside the Top Cover.")
→P.406
→P.408
→P.399
→P.401
Corrective Action
→P.401
→P.399
→P.419
→P.584
User's Guide
iPF765