Changing The Type Of Paper - Canon imagePROGRAF iPF765 User Manual

Changing the Type of Paper

Note
8
Holding it at the positions indicated, close the Roll Cover.
Note

Changing the Type of Paper

Changing the Type of Paper
Follow these steps to change the type of paper specified on the printer after you have loaded paper.
If you will continue using this type of paper later, selecting Keep Paper Type > On will save the time and effort of
configuring the media type setting when you load the paper again. The current media type settings before you se-
lect On will be automatically selected at that time. (See "Using the Same Type of Paper Regularly.")
•
For best printing results, the printer fine-tunes the print head height and the feed amount for each type of paper. Be sure
to select the type of paper to use correctly before printing.
Important
•
Because the printer fine-tunes the feed amount for each type of paper, the margins and the size of printed images may
vary depending on the type of paper used. If margins and the size of images are not as you expected, adjust the paper
feed amount.
(See "Adjusting the Feed Amount.")
Changing the Type of Paper
•
When you load a roll, a menu for selection of the type of paper is shown on the Display Screen. Select the type of paper,
and then press the OK button.
Note
If no barcode has been printed on the roll and you have set ManageRemainRoll to On, specify the roll length after the
type of paper. (See "Specifying the Paper Length.")
1
On the Tab Selection screen of the Control Panel, press ◀ or ▶ to
select the Paper tab (
Note
404
2
Press the OK button.
The Paper Menu is displayed.
3
Press ▲ or ▼ to select Chg. Paper Type, and then press the OK button.
4
Press ▲ or ▼ to select the type of paper loaded ( Roll Paper or Cut Sheet), and then press the OK but-
ton.
•
For details on types of paper to select, see the Paper Reference Guide. (See "Types of Paper.")
•
Cut the edge of the roll after the paper is advanced if it is soiled or if there are cuts from scissors or the blade
after removing creased edges. (See "Specifying the Cutting Method for Rolls.")
).
•
If the Tab Selection screen is not displayed, press the Menu button.
→P.555
→P.405
iPF765
→P.394
→P.412
→P.405
User's Guide