Cannot Load Sheets; Paper Is Not Cut Neatly; Paper Is Not Cut; Depression On The Leading Edge Is Left - Canon imagePROGRAF iPF765 User Manual

iPF765

Cannot load sheets

Cannot load sheets
Cause
The paper source selection is incorrect.

Paper is not cut neatly

Paper is not cut neatly
Cause
The paper is bent or curled at the cut position.
Paper rises by the ends of the cut position before it is
cut.
You are using paper that cannot be cut with the Cut-
ter Unit.
Cut Speed is not configured correctly in the Control
Panel menu.
During cutting, printed documents fall out at an angle.

Paper is not cut

Paper is not cut
In the printer driver, No or Print Cut Guideline is specified in Auto
Cut.
In the Control Panel menu, Cutting Mode is set to Eject or Manual.

Depression on the leading edge is left

Depression on the leading edge is left
Cause
Keeping a roll in the printer for a long time without
printing on it may leave a depression on the lead-
ing edge.

The size of clear film cannot be detected

The size of clear film cannot be detected
Cause
The Platen is soiled with ink or other substances.

Roll Paper is Continuously Ejected

Roll Paper is Continuously Ejected
Cause
Although sheets are se-
lected as the paper
1.
source, a roll was ad-
2.
vanced.
3.
4.
5.
User's Guide
Press the Load button and select the paper source.
Straighten out any curling by the edges of the paper.
Reload the paper correctly.
Specify Manual in Cutting Mode in the Control Panel menu and use scissors or a
cutting tool to cut the roll after printing.
(See "Specifying the Cutting Method for Rolls.")
Change the Cut Speed setting in the Control Panel menu.
(See "Menu Structure.")
In the Control Panel menu, set Cutting Mode to Eject. Hold documents after
printing, as they are cut.
(See "Specifying the Cutting Method for Rolls.")
Cause
When printing quality is most important, we recommend setting TrimEdge Reload to
On or Automatic so that the paper edge is automatically cut before printing.
(See "Menu Structure.")
Open the Top Cover and clean the entire Platen.
(See "Cleaning Inside the Top Cover.")
After roll ejection stops, follow these steps to reload the roll.
Push the Release Lever back.
Open the Roll Cover.
Using both hands, rotate the Roll Holder toward the back to rewind the roll. At this time, ensure that both
ends of the roll are rewound evenly.
Pull the Release Lever forward.
Load the roll. At this time, be sure to press the Load button and select Load Roll Paper.
(See "Loading Rolls in the Printer.")
Corrective Action
Corrective Action
→P.444
Specify Yes in Auto Cut in the printer driver.
If the Cutting Mode is Eject, press the Cut button to cut the paper.
If the Cutting Mode is Manual, cut rolls with scissors or the like.
Corrective Action
→P.444
Corrective Action
→P.584
Corrective Action
→P.401
Cannot load sheets
→P.412
→P.412
Corrective Action
603