Load A Media Roll (Position 2) - Oce PlotWave 300 User Manual

Load a media roll (position 2)

Load a media roll (position 2)
Note:
When your printing system is equipped with an additional second media roll, it is advised
to load an A0 media roll on position 1 and an A2 media roll on position 2.
Attention:
Handle the media roll with care. A dented media roll can damage the printer.
Attention:
Please refer to the list of
sponding media name that you must select on your user panel.
Attention:
Always write the correct media name inside the core, after you unpack the media roll. In
that case, if you replace a media roll before it is empty and you want to re-use it later,
you will have the correct media information available.
Caution:
Watch your fingers when you handle the media roll.
Caution:
If you want to load an A0 media roll on position 2, you must make sure to bend your
knees as indicated below.
Illustration
[235] Bend your knees when you load an A0 media roll on position 2
244 Chapter 6 - Maintain the printing system
'Preferred Océ media types and sizes' on page 300 to find the corre-