Make A Copy With A Stamp - Oce PlotWave 300 User Manual

Make a copy with a stamp

Make a copy with a stamp
Introduction
A stamp is a pre-defined text you can set on every copy.
Before you begin
If you must enter the same value for a setting very often, you can set this value as the de-
fault value for that setting in the Océ Express WebTools.
After you press the start key, the user panel always shows the job number and status of
the job. A copy job appears temporarily in the 'Jobs - Queue' section of the Océ Express
WebTools, a scan job appears in the Smart Inbox 'Scans'.
How to make a copy with a stamp
Feed the original face up and centred on the original feeding table.
1.
Note:
You do not need to centre the original precisely. The exact position of the original is au-
tomatically detected by the scanner.
The 'Copy' tab is automatically activated on the user panel.
Open the 'Copy' tab with the confirmation button above the scroll wheel.
2.
Define the job settings.
3.
Open a template with the confirmation button .
Scroll to 'Stamp' and open this setting with the confirmation button .
Scroll to 'Stamp', select a stamp with the scroll wheel and confirm.
Scroll to 'Position', select the correct position with the scroll wheel and confirm.
Scroll to 'Size', select the correct size with the scroll wheel and confirm.
Scroll to 'Colour', select the correct colour with the scroll wheel and confirm.
Define the number of copies and press the green button.
4.
Result
The copy contains the selected stamp.
184 Chapter 5 - Use the printing system