Configure A Remote Scan Destination - Oce PlotWave 300 User Manual

Configure a remote scan destination

Configure a remote scan destination
Note:
Before you can edit a setting or a settings group, you must log on as System administrator
or Power user.
Create a web destination with FTP
Create a home directory and a subdirectory on a workstation. For example c:Ftp/Scan
1.
Enable FTP on the workstation
2.
Click 'Configuration' - 'Scan destinations'.
3.
Click 'Edit' in a 'Scan destinations' bar.
4.
Enter a name for the scan destination.
5.
This name will appear on the user panel.
Place a check mark in the enabled box.
6.
Select 'Remote via FTP'.
7.
For access to the directory on the workstation through FTP, a user name and password
8.
is set on the FTP server that runs on the workstation. Enter this 'Remote user name' and
this 'Remote password' in the required fields.
Note:
Make sure the user has write-access privileges on the destination.
Enter a path name of the 'Remote folder'.
9.
The path name is the "system-name-of-remote-workstation/subfolder". This is case
sensitive.
Note:
Find the system name of the remote workstation on the control panel of the workstation
(Control panel - Network - Identification - System name)
Enter a file name for your scanned files.
10.
The file extension depends on the scanned file type that you select when you start your
scan job on the user panel.
If you enter a generic name, for example: scan###.*, the scanned files automatically get
a unique file name. An ascending number replaces the "###".
Enter a start value for ###. If you enter 001, the first scanned file is named scan001.*.
11.
Click 'Ok' to confirm your entries or 'Cancel' to reject your entries.
12.
114 Chapter 4 - Define your workflow with the Océ Express WebTools