5. SYSTEM MAINTENANCE REFERENCE
5.1 SERVICE PROGRAM
Do not let the user access the SP mode or the SSP mode. Only service representatives
are allowed to access these modes. The machine operation is NOT guaranteed after
any person other than service representatives accesses the SP mode.
Make sure that the data-in LED ( ) is not on before you go into the SP mode. This
LED indicates that some data is coming to the machine. When the LED is on, wait for
the copier to process the data.
5.1.1 USING SP AND SSP MODES
The following two modes are available:
SP Mode (Service Program Mode): The SP Mode includes the programs that are
necessary for standard maintenance work. To enter the SP mode, consult your supervisor.
SSP Mode (Special SP Mode): The SSP Mode includes SP-Mode programs and some
special programs. You need some extra knowledge to use these special programs. For
details, consult your supervisor.
5.1.2 TYPES OF SP MODES
System SP: SP modes related to the engine functions
Printer SP: SP modes related to the controller functions
Scanner SP: SP modes related to the scanner functions
Fax SP: SP modes related to the fax functions
Select one of the Service Program modes (System, Printer, Scanner, or Fax) from the touch
panel as shown in the diagram below after you access the SP mode. This section explains the
functions of the System/Printer/Scanner SP modes. Refer to the Fax service manual for the Fax
SP modes.
SM
5-1
Service Program
M052/M053/M054