Df Image Adjustment - Ricoh M052 Service Manual

The diagrams show the paper on the copy tray. Note that the paper is output with the
face down.
SP
SP4-008-001 (Sub Scan
Magnification Adj)

4.3.3 DF IMAGE ADJUSTMENT

Perform the adjustment procedure in this section only when the ARDF is installed on
the copier.
1. Make a temporary test chart as shown in the above diagram. Use the "A4/8.5 x 11" paper to
make it.
2. Place the temporary test chart on the ARDF.
3. Make a copy.
4. Measure the distance between the side edge of the image area and the side edge of the
paper [A].
(The diagram shows the paper on the copy tray. Note that the paper is output with the face
down.)
5. Adjust the side-to-side registration (S to S/Front Regist: SP6-006-001, S to S/Rear Regist:
SM
Specification
± 1.0%
4-9
Adjusting Copy Image Area
M052/M053/M054