Ricoh M052 Service Manual page 63

Controller Options
end of this section).
4. Peel off the cover from the double-sided tape on the Velcro fasteners [A], and then attach
the fasteners [A] at the scanner left cover of the machine.
5. Attach the antennas [B] to the fasteners on the scanner left cover.
6. Attach eight clamps as shown above.
7. Wire the cables and clamp them (
Make sure that the cables are not slack. Keep them wired tightly along the covers.
You may have to move the machine if the reception is not clear.
Make sure that the machine is not located near an appliance or any type of equipment that
generates strong magnetic fields.
Put the machine as close as possible to the access point.
M052/M053/M054
x 8).
2-32 SM