Dedicated Transmission Parameters; Programming Procedure - Ricoh M052 Service Manual

Hide thumbs Also See for M052:

Table of Contents

4.5 DEDICATED TRANSMISSION PARAMETERS

There are two sets of transmission parameters: Fax and E-mail

Each Quick Dial Key and Speed Dial Code has eight bytes of programmable parameters

allocated to it. If transmissions to a particular machine often experience problems, store that

terminal's fax number as a Quick Dial or Speed Dial, and adjust the parameters allocated to that

The programming procedure will be explained first. Then, the eight bytes will be described.

Set the bit 0 of System Bit Switch 00 to 1.

Enter Address Book Management mode ([User Tools]> System Settings> Key Operator>

Address Book Management).

Select the address book that you want to program.

For the fax parameter, select "Fax Dest.", for the E-mail parameter, select "E-mail", then

press "Start". Make sure that the LED of the Start button lights green.

The settings for the switch 00 are now displayed. Press the bit number that you wish to

To scroll through the parameter switches, either:

Select the next switch: press "Next" or Select the previous switch: "Prev." until the correct

switch is displayed. Then go back to step 6.

After the setting is changed, press "OK".

After finishing, reset bit 0 of System Bit Switch 00 to 0.

Dedicated Transmission Parameters

Table of Contents