Ricoh M052 Service Manual page 281

Dial Up Password
Use this SP to set a password for access to remote dial up. Follow these rules
when setting a user name:
157
Name length: Up to 32 characters
Spaces and # allowed but the entire entry must be enclosed by double
quotation marks (").
Local Phone Number
Use this SP to set the telephone number of the line where embedded RCG-M
161
is connected. This number is transmitted to and used by the Call Center to
return calls.
Limit: 24 numbers (numbers only)
Connection Timing Adjustment: Incoming
When the Call Center calls out to an embedded RCG-M modem, it sends a
repeating ID tone (*#1#). This SP sets the time the line remains open to send
these ID tones after the number of the embedded RCG-M modem is dialed up
162
and connected.
[0 to 24 / 1 / 1 /step]
The actual amount of time is this setting x 2 sec. For example, if you set "2"
the line will remain open for 4 sec.
Access Point
This is the number of the dial-up access point for RCG-M. If no setting is done
for this SP code, then a preset value (determined by the country selected) is
163
used.
Default: 0
Allowed: Up to 16 alphanumeric characters
SM 5-65
System SP5-xxx
M052/M053/M054