Cannot Send By Alias Fax Number - Ricoh M052 Service Manual

11 Remote fax a G3 fax?
12 G3 fax is connected to VoIP gateway?
13 Remote G3 fax turned on?
14 Network bandwidth too narrow?

Cannot send by Alias Fax number.

Check Point
1 LAN cable connected?
2 Number of specified Alias fax correct?
3 Firewall/NAT installed?
4 Transmission sent manually?
5 Gatekeeper installed correctly?
6 Gatekeeper power switched on?
IP address/host name of Gatekeeper
7
correct?
DNS server registered when Gatekeeper
8
host name specified?
9 Enable H.323 SW is set to on?
SM
Check that the remote fax is a G3 fax.
Check that G3 fax is connected.
Check that G3 fax is switched on.
Request the network administrator to
increase the bandwidth.
Raise the network delay level.
IPFAX SW 01 Bit 0 to 3
IP-Fax bandwidth is the same as the
DCS speed. Set IP-Fax SW00 Bit 6 to
1.
Action
Check the LAN cable connection.
Confirm the Alias of the remote fax.
Error Code: 13-14
Cannot breach the firewall. Send by
using another method (Fax, Internet
Fax)
Manual sending not supported.
Contact the network administrator.
Contact the network administrator.
Check the IP address/host name.
Contact the network administrator.
Check the settings.
See User Parameter SW 34 Bit 0
29
IP-Fax Troubleshooting
M381