Ricoh M052 Service Manual page 587

Communication Switch 14 [SP No. 1-104-021]
No FUNCTION
Inch-to-mm conversion during
0 transmission
0: Disabled 1: Enabled
1-5 Not used
Available unit of resolution in
which fax messages are
received
Bit 7: 0, Bit 6: 0 = mm
6-7
Bit 7: 0, Bit 6: 1 = inch
Bit 7: 1, Bit 6: 0 = mm and inch
(default)
Bit 7: 1, Bit 6: 1 = Not used
Communication Switch 15 – Not used (do not change the settings)
Communication Switch 16 [SP No. 1-104-023]
No FUNCTION
0-7 Not used
SM
COMMENTS
0: In immediate transmission, data scanned in inch
format are transmitted without conversion.
In memory transmission, data stored in the SAF
memory in mm format are transmitted without
conversion.
Note: When storing the scanned data into SAF
memory, the fax unit always converts the data into
mm format.
1: The machine converts the scanned data or
stored data in the SAF memory to the format
which was specified in the set-up protocol
(DIS/NSF) before transmission.
Do not change the factory settings.
For the best performance, do not change the
factory settings.
The setting determined by these bits is informed to
the transmitting terminal in the pre-message
protocol exchange (in the DIS/NSF frames).
COMMENTS
Do not change the factory settings.
81
Bit Switches
M381