Honeywell LYNX Touch Series Installation And Setup Manual page 24

LYNX Touch Installation and Setup Guide
Programming the Control
Screen
Phone Detect Time
2 Minutes
Remote Phone
Enabled
Events - Log All
Press To Log All
Events – Log Alarm
Enabled
Remote Access Serial
Disabled
Non Security
Disabled
Multi Mode Serial
Disabled
8. If Keypad or Trouble was selected in Step 7, the "Phone Detect Time" option is
displayed. Select "Phone Detect Time". The system scrolls between the following options:
1 Minute
2 Minutes
3 Minutes
4 Minutes
9. Select "Remote Phone". The System toggles between the following options:
Disabled
Enabled
Use the down arrow to scroll to the next page of options.
10. Select "Events - Log All". The system displays "Press To Log All". Selecting this option
programs the system to log all events and "Log All Set" is displayed. Additionally all of the
options listed below are enabled.
Events – Log Alarm
Events – Log Bypass
Events – Log Open/Close
Events – Log Trouble
Non-Security
OR
Proceed to step 11 and select the options individually.
11. Select "Events – Log Alarm". The System toggles between "Enabled" and "Disabled.
12. Select "Events – Log Bypass". The System toggles between "Enabled" and "Disabled".
13. Select "Events – Log Open/Close". The System toggles between "Enabled" and
"Disabled".
14. Select "Events – Log Trouble". The System toggles between "Enabled" and "Disabled".
15. Select "Remote Access Serial". The System toggles between "Enabled" and "Disabled".
If the Remote Access Serial" option is enabled, the "Multi Mode Serial" option is
displayed.
16. Select "Non Security". The System toggles between "Enabled" and "Disabled".
17. Select "Multi Mode Serial". The System toggles between "Enhanced Reports" and
"Disabled".
18. Select "Save" when complete.
ACTION
- 24 -