Honeywell LYNX Touch Series Installation And Setup Manual page 34

LYNX Touch Installation and Setup Guide
Programming the Control
Notes: If applicable, preprogrammed defaults for the LYNX Touch Control are shown on the screen unless otherwise noted.
When GSM is used as the Primary Communications channel for any Total Connect service, the GSM Radio must be
selected as the Primary Reporting Path (Preferred Radio).
SCREEN
Reporter
Primary CS Info
Phone Type
Contact Id: 4 Digit
Communicator Type
None
Phone Number
Account Number
FFFF
Dynamic Priority
Redundant Reports
Dynamic Delay
30 Seconds
Report All
Press to Report All
Report Alarms
Enabled
Report Troubles
Enabled
Report Open/Close
Disabled
Report Tests
Enabled
Secondary CS Info
Select "Reporter"
The System displays the following options:
Primary CS Info
Follow Me Phone 1
Report Selection
Downloader
Select "Primary CS Info". The System displays the following options:
Phone Type
Select "Phone Type". The System scrolls though the following options:
None
Contact Id: 4 Digit
Contact Id: 10 Digit
SIA
Select "Communicator Type". The System scrolls though the following options:
None
GSM
WiFi
WiFi & GSM
IP
Note: The system will display the communications (GSM or IP) paths based upon the selection made
in Communicator Programming. The Communication Path selection can be enabled for either
Primary Central Station or Secondary Central Station but not both. If it is enabled in one it will
not be available for the other Central Station. If APL is used, GSM or IP must be selected as the
Primary Communicator Type.
If any option other than "None" is selected in "Phone Type" The "Phone Number" option will
be displayed. Select "Phone Number". Enter the Primary Central Station Phone Number on
the displayed keypad. (Up to 20 digits)
If any option other than "None" is selected in "Phone Type" The "Account Number" option
will be displayed. Select "Account Number". Enter the Primary Central Station Account
Number on the displayed keypad.
If any option other than "None" is selected in "Communicator Type" The "Dynamic Priority"
option will be displayed. "Select "Dynamic Priority". The system scrolls between "Redundant
Reports", "Preferred Telco" and Preferred Radio".
If any option other than "Redundant Reports" is selected in "Dynamic Priority" The "Dynamic
Delay" option will be displayed. "Select "Dynamic Delay". The system scrolls between "15
Seconds", "30 Seconds", "60 Seconds" and "90 Seconds".
Note: If GSM is selected as the primary reporting channel Dynamic Delay should be set to minimum
of 60 seconds.
Select "Report All". The System toggles between "Press to Report All" and "Report All Set".
If "Report All" is selected all reporting options will be "Enabled". Select the "Save" key to
return to the Reporter options screen.
Select "Report Alarms". The System toggles between "Disabled" and "Enabled".
SIA: The LYNX Touch default is "Enabled".
Select "Report Troubles". The System toggles between "Disabled" and "Enabled".
SIA: The LYNX Touch default is "Enabled".
Select "Open/Close". The System toggles between "Disabled" and "Enabled".
Select "Report Tests". The System toggles between "Disabled" and "Enabled".
SIA: The LYNX Touch default is "Enabled" and is not selectable.
Select "Secondary CS Info". The System displays the following options:
Phone Type
ACTION
Secondary CS Info
Follow Me Phone 2
Options
Communicator Type
Communicator Type
- 34 -