Enroll Using Scan Access Points; Manually Configure Access Points - Honeywell LYNX Touch Series Installation And Setup Manual

LYNX Touch Installation and Setup Guide
Programming the Control
SCREEN
WiFi Location
None

Enroll using Scan Access Points

Note: If the preferred access point is not available after scanning, manually select the network via the "Manually Configure
Access Points" procedure.
1. Select "Scan Access Points". The available networks and signal strength are displayed. Use the down
arrow to scroll to the next page of options. Use the
System Programming...
SSID = Vtek, RSSI = -69dbm
SSID = JimC, RSSI = -50dbm
SSID = Toms_net, RSSI = -80dbm
Edit Scan
2. Select the desired Network and then press the "Edit" button. The network information is displayed. Select the
"Join" button. A confirmation screen will be displayed.
3. Select "OK", then select "Save" to confirm the selection.
4. Select the " " button two times. The Ethernet information will be displayed. Signal strength will be indicated
by a series of colored bars along with the RSSI level (in dBM).
Bars
4 White
1 Yellow, 3 White
2 Yellow, 2 White
3 Yellow, 1 White
4 Yellow

Manually Configure Access Points

Note: For WEP Security type, the LYNX Touch supports the Key Index 1 in open system authentication mode.
1. Select "Manually Configure AP", the following screen is displayed.
System Programming...
SSID Name
Security Network Type
Open Infrastructure
Key
* * * *
Join Static
2. Select "SSID Name" and then enter a name (not to exceed 31 characters) on the displayed keyboard.
3. Select "Security". The system scrolls between the following options:
Open
WPA1
WPA2
WEP*
When configuring for WEP encryption key on the access point, always use hexa-decimal type as the input method.
4. Select "Network Type". The system scrolls between "Infrastructure" and "Ad-Hoc".
2. Select "WiFi Location". The System will scroll between "None" and "Speaker Side". After
selecting "Speaker Side", the "Configure WiFi" option will be displayed.
3. Select "Configure WiFi". The following options will be displayed":
Scan Access Points
Manually Configure AP
WPS*
5100-100-091-V1
Meaning
No connection
Weak
Fair
Good
Excellent
DHCP
Yes
Save
5100-100-034-V0
ACTION
arrow to return to the previous page.
RSSI range (dBM)
-255 (used internally)
-81 or higher
-71 to -80
-51 to -70
-50 or less
- 48 -
* If available