System Operation; Key/Touchscreen Operation; Panic Key/Icons; Security Codes - Honeywell LYNX Touch Series Installation And Setup Manual

Hide thumbs Also See for LYNX Touch Series:
Table of Contents

Advertisement

LYNX Touch Installation and Setup Guide

System Operation

Key/Touchscreen Operation

The keys and touchscreen allows the user to arm and disarm the system, and perform other system
functions, such as bypassing zones. Zone and system conditions (ALARM, trouble, bypass) are displayed on
the display. When an alarm occurs, console sounding and external sounding will occur, and the zone(s) in
alarm will be displayed on the display. Pressing any key will silence the keypad sounder for 10 seconds (only
once). Disarming the system will silence both console and external sounders. When the system is disarmed,
any zones that were in an alarm condition during the armed period will be displayed (memory of alarm). To
clear this display, simply repeat the disarm sequence by pressing the OFF key and entering the Security
Code. The console also features chime annunciation, and three panic key icons for silent, audible, fire or
personal emergency alarms. These keys can notify the central station of an alarm condition, if that service
is connected.

Panic Key/Icons

There are three panic key icons that, if programmed, are displayed on the virtual keypad when the "PANIC"
key is depressed for four seconds. The panic key screen will timeout if a selection is not made within ten
seconds. The keys can be used to manually initiate alarms and send a report to the central station. Each can
be individually programmed for 24-hour silent, audible, personal or fire emergency responses. The panic
function is activated when the respective keys is pressed. The panic functions are identified by the system as
follows:
Zone
Function
95
Fire Emergency
96
Medical Emergency
99
Police Emergency
Important: For the silent panic functions to be of practical value, the system must be connected to a central station.

Security Codes

Installer Code

The installer programs the 4-digit Installer Code initially as part of the programming procedure. The
factory default Installer Code is 4-1-1-2, but may be changed in the Installer Code programming
field. The Installer Code is the only code that allows entry into Installer Programming mode.

Master Code

In normal operation mode, the Master Code is used to enter the 4-digit User Security Codes.

Enter/Change the Master Code by installer.

The factory default Master Code for the LYNX Touch Control is set to 1-2-3-4. The Master Code is used to
enter the 4-digit User Security Codes.
SCREEN
Ready To Arm
Users
Events
Date Time
Reminders
Slide Show
Master ****
1.
After entering the User Tools/Programming Menu, select the "Users" icon
on the User Menu screen. The system displays the User Code
Programming screen
Test
Keypad
WiFi Config
Back
5100-100-006-V0
3.
Select "Master", then select "Edit".
3. Enter a new four-digit Master Code on the displayed keypad The system
will display the new code on the left side of the screen.
4. Select "Done" when you are finished.
5.
The system returns to the User Code Programming screen.
ACTION
- 52 -

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents