Input Compensation Of Multi-Speed And Remote Setting (Pr. 28); Remote Setting Function (Pr. 59) - Mitsubishi Electric FR-A700 Instruction Manual

Frequency setting by external terminals

4.11.3 Input compensation of multi-speed and remote setting (Pr. 28)

By inputting the frequency setting compensation signal (terminal 1, 2), the speed (frequency) can be
compensated for relative to the multi-speed setting or the speed setting by remote setting function.
Parameter
Number
Multi-speed input
28
compensation selection
REMARKS
⋅ Select the terminal (terminal 1, 2) used for compensation input voltage (0 to ±5V, 0 to ±10) using Pr. 73 Analog input selection.
⋅ When using terminal 1 for compensation input, set "0" (initial value) in Pr. 868 Terminal 1 function assignment.
♦ Parameters referred to ♦
Pr. 4 to Pr. 6, Pr. 24 to Pr. 27, Pr. 232 to Pr. 239 (multi-speed operation)
Pr. 73 Analog input selection
Pr. 59 Remote function selection
Pr. 868 Terminal 1 function assignment

4.11.4 Remote setting function (Pr. 59)

Even if the operation panel is located away from the enclosure, you can use contact signals to perform
continuous variable-speed operation, without using analog signals.
Parameter
Number
59 Remote function selection
Inverter
Forward
rotation
STF
Acceleration
RH
Deceleration
RM 10
Clear
RL
2
SD 5
Connection
diagram for remote setting
(1) Remote setting function
⋅ Use Pr. 59 to select whether the remote setting function is used or not and whether the frequency setting storage
function in the remote setting mode is used or not.
When Pr. 59 is set to any of "1 to 3" (remote setting function valid), the functions of the RH, RM and RL signals are
changed to acceleration (RH), deceleration (RM) and clear (RL).
⋅ When the remote function is used, the output frequency of the inverter can be compensated for as follows:
External operation .. Frequency set with RH and RM operation + external operation frequency other than multi-speed
PU operation ...........Frequency set by RH/RM operation + PU running frequency
170
Name Initial Value
Refer to page 282
Refer to page 170
Refer to page 281
Name Initial Value Setting Range
*
0Hz
ON
Acceleration
(RH)
Deceleration
(RM)
Clear (RL)
Forward
rotation (STF)
Power supply
* External operation frequency (other than multi-speed) or PU running frequency
(PU operation frequency when Pr. 79 = "3" (external, PU combined)) and terminal 4 input.
(When making analog input compensation, set "1" in Pr. 28 Multi-speed input compensation
selection.
When Pr. 28 is set to "0" and acceleration/deceleration is made to reach the set frequency of
the analog voltage input (terminal 2 or terminal 4) by RH/RM, the auxiliary input by terminal 1
becomes invalid.)
Setting Range
0
0
1
Refer to page 166
0
1
2
0
3
ON
ON
ON
ON
Description
Without compensation
With compensation
Description
RH, RM, RL signal Frequency setting
function storage function
Multi-speed setting
Remote setting
Remote setting
(Turning STF/STR off
Remote setting
clears remotely- set
When Pr. 59 = 1
When Pr. 59 = 1, 2
When Pr. 59 = 3
When Pr. 59 = 2, 3
ON
ON
ON ON
⎯
Yes
No
No
frequency.)
Time
ON
ON