Dual Esc Mixing "Dual Esc - FUTABA 4PK-2.4G SuperR Instruction Manual

This function is mixing used with crawlers and other 4WD type vehicles and uses the
2nd CH to control the front motor controller and the 4th CH to control the rear motor
controller.
The switch which switches drive among front side only, rear side only, and both front
side and rear side (4WD) is set from among DT1, 2, 3, 4, DL1, 2, 3 by the function dial
function (p.98).
Setting Special mixings
When 4th CH was set at ACT at Brake Mixing (p.74) or when CPS-1 Mixing (p.94) is
used, Dual ESC Mixing cannot be used.
Press t
Dual ESC mixing adjustment
(Preparation)
This function is used to switch between front drive/4WD/ rear
drive with a dial or digital trim, the switch used by the func-
tion select dial function (p.98) is set.
1
(Dual ESC setting)
Operate the (JOG) button up and down and select the set-
ting item "MODE". Set the function by pressing the (+) or (-)
button.
"INH" :Function OFF
"ON" :Function ON
90

Dual ESC Mixing "DUAL ESC"

he button
Special Mixes "S-MIX" (DUAL ESC)
•Select the setting item by
button
* b l i n k s a t t h e c u r r e n t
setup item.
When the dial set at the initial
screen is operated, the mode (F/
R, F, R) is displayed at the ESC
part.
The row that is displayed de-
pends on the set dial.
The figure is an example of set-
ting to DL3.
Setup items
MODE : Function ON/OFF
FRNT : 2ch rate (Front side)
REAR : 4ch rate (Rear side)
MXMD : Mix mode
TRIM : Trim mode
Display when ESC type switch-
ing dial is not set.
Function ON/OFF (MODE)
INH, ON