Initial Set-Up; Preparations (Transmitter) - FUTABA 4PK-2.4G SuperR Instruction Manual

Before setting the Transmitter functions, check and set items 1 to 5 below.
(Display when power switch turned on)
When the power switch is turned on, the currently selected model number is displayed.
Check if this number is the model number you want to set-up. To change the model
number, use the Model Select function (See page 108).
1.RF Output Check
If signals are output normally, RF output monitor "RF" will be displayed on the screen.
If "RF" is not displayed, contact your Futaba dealer.
When radio waves are not being emitted when turned on
by display switch and when the DSC function is used,
"DISP" is displayed.
2.Rx Type Check
The T4PKSR transmitter can use the Futaba 2.4GHZ R603FS/FF. However, there
are two types of Futaba 2.4GHz receivers for vehicles: "C1" type and "C2" type. The
R603FS and 603FF are "C1" type. The R614FF supplied with
the 4PKS set as standard is the "C2" type. Check that the set-
ting matches the receiver being used. For example, when using
the R614FF, the receiver type must be set to FASST-C2 and
when using an R603FS or R603FF, the receiver type must be
set to FASST-C1. If the setting is wrong, change it using the
RX/SX type select function (See page 46).

Initial Set-Up

Preparations (Transmitter)

Turn on the transmitter power.
(Start screen)
The model number is displayed.
When radio waves are not being emitted when
turned on by display switch and when the
DSC function is used, "DISP" is displayed.
When FASST-C2
"RF"
"C2"
35