Installation Safety Precautions - FUTABA 4PK-2.4G SuperR Instruction Manual

 Warning
Receiver (receiver antenna)
 Do not cut or bundle the receiver antenna wire.
 Do not bundle the receiver antenna wire together with the motor controller lead wire.
 Keep the receiver antenna wire at least 1cm away from motor, battery, and other wiring carrying heavy current.
 Do not use a metal receiver antenna holder on a plate made of metal, carbon, or other conductive material.
 Install the receiver antenna holder as closely as possible to the receiver.
If the antenna wire is cut, bundled, or routed near a noise source, the receiving sensitivity will drop, the running (sailing)
range will decrease, and you may lose control of the model.
*Noise is transmitted through metal, carbon, and other conductive material, so keep the receiver antenna wire away from such parts.
Antenna
Install the receiver as far away as possible from the bat-
tery, motor controller, motor, silicon cord and other noise
sources. Keep it away from the antenna wire, in particular.
Receiver Vibration-proofing / Waterproofing
(Car)
 Vibration-proof the receiver by wrapping it in foam rubber or other vibration-absorbing material
and mount it with thick double-sided tape.
 When using the receiver holder supplied with the model kit, mount the holder to the chassis
through a rubber grommet.
(Boat)
 Vibration-proof the receiver by wrapping it in foam rubber or other vibration-absorbing material.
Also waterproof the receiver by sealing it in a plastic bag.
If the receiver is exposed to strong vibration and shock, it will operate erroneously due to the invasion of water drops and
you may lose control of the model.
When using the receiver holder sup-
plied with the kit, install the receiver
through a rubber grommet.
32

Installation Safety Precautions

Battery
Screw
Mechanical plate
Damper
Nut (as required)
Receiver holder
Antenna holder
Install the antenna holder as close as possible to the
receiver. The surplus antenna wire from the receiver
to the antenna holder is affected by noise. Do not use
a metal antenna holder on a plate made of metal, car-
bon, or other conductive material.
Foam rubber, etc.
Wrap the receiver in foam rubber or other
vibration-absorbing material. Do not use
hard material. Hard material does not
have a vibration-proofing effect.
Mechanical plate
When mounting the receiver with double-sided tape,
do not use a stiff tape. Stiff tape does not have a vibra-
tion-proofing effect.
Antenna wire does
not touch the plate.
Thick double-
sided tape