FUTABA 4PK-2.4G SuperR Instruction Manual page 70

- ABP : Amount of brake return
Sets the rate at which the ser-
vo returns versus trigger oper-
ation for brake release. When
set to 0%, the ABS function
is not performed. When set to
50%, the servo returns 50%
(1/2) of the trigger opera-
tion amount and when set to
100%, the servo returns to the
neutral position.
- DLY : Delay
Sets the delay from brake op-
eration to ABS operation. When set to 0%, the ABS function is activated without any
delay. At 50%, the ABS function is activated after a delay of approximately 0.7 second
and at 100%, the ABS function is activated after a delay of approximately 1.4 seconds.
- CYC : Cycle speed
Sets the pulse speed (cycle). The smaller the set value, the faster the pulse cycle.
- MODE : Function ON/OFF
ABS function ON/OFF setting. When using the ABS function, set to "ACT(ON)".
- TGP : Trigger point
Sets the trigger point at which the ABS function begins to operate at brake operation.
- DTY : Cycle duty ratio
Sets the proportion of the time the brakes are applied and the time the brakes are re-
leased by pulse operation. The ratio can be set to +3 ~ 0 ~ -3 in 7 steps.
- STM : Steering mixing
Sets ABS operation ON/OFF according to the steering operation range.
L 50%
70
N50%
N 50%
Steering operation
A.B.S. operation range
indicated by " "
DTY (duty): X and Y ratio
X: (Brake application time)
TGP (Trigger point)
Trigger operation
R L 50%
A.B.S. operation range
indicated by " "
A.B.S Function "A.B.S"
A.B.S
Y: (Brake return time)
CYC (Cycle)
E50%
N 50%
Steering operation
A.B.S. operation range
indicated by " "
ABP
(Amount of
brake return)
R