Mechanical Atl Adjustment; Wheel & Trigger Tension Adjustment - FUTABA 4PK-2.4G SuperR Instruction Manual

Mechanical ATL Adjustment

Make this adjustment when you want to decrease the stroke of the brake (back) side of
the throttle trigger for operation feel.
Adjustment
1
Using a 2.5mm hex wrench, adjust the trigger
brake (reverse) stroke. (The screw moves the
throttle trigger stopper.)
• When the screw is turned clockwise, the stroke becomes
narrower. Adjust the stroke while watching the screw.
Note:
Once you have changed the mechanical stroke on the brake side, be sure to adjust
the scale of the throttle channel accordingly by using the "Adjuster Function"
(page 116).
Due to this change, you also need to adjust in most cases the travel of the throttle
servo by using "Data Setting."
Wheel & Trigger Tension Adjustment
Make this adjustment when you want to change the wheel or trigger spring's tension.
Adjustment
1
Using a 1.5mm hex wrench, adjust
the wheel spring tension by turning
the screw inside the adjusting hole in
the arrow direction.
• The spring is set to the weakest tension at the
factory.
• When the adjusting screw is turned clockwise,
the spring tension increases.
Note:
The adjustment range is up to 7 to 8 turns from the fully tightened (strongest) po-
sition. If turned farther than this, the adjusting screw may fall out.
18
Mechanical ATL
adjusting screw
Wheel tension
adjusting screw
Trigger tension
adjusting screw