FUTABA 4PK-2.4G SuperR Instruction Manual page 111

"SINGLE" mode
"MENU COPY" mode
Model copying
(Preparation)
Select setting item "MODE" by (JOG) button up or down op-
eration and select the copy mode from "SINGLE", "GROUP",
"MENU COPY", and "SW/DIAL COPY" by pressing the (+) or
(-) button.
- When executing the model copy function, always select the copy mode
first. If the copy mode is changed after the copy source (MST) and copy
destination (STV) models were decided, it may become necessary to re-
select MST and SLV because the copy source (MST) and copy destination
(SLV) models return to the M1~M2 initial value.
1
(Copy source model No. selection)
Select the setting item "MST" by (JOG) button up or down op-
eration. Press the (+) or (-) button and select the model #.
2
(Copy destination model No. selection)
Select the setting item "SLV" by (JOG) button up or down opera-
tion. Press the (+) or (-) button and select the model #.
- For the model currently in use (including group), "CAN NOT COPY" blinks at the
bottom of the screen to alert the operator that the model cannot be copied.
3
(Copy execution)
Select the setting item "EXEC" by (JOG) button up or down
operation. Press the (+) and (-) buttons simultaneously for
1 second. When "COMPLETE!" blinks at the bottom of the
screen, copying is complete.
4
When ending setting, return to the initial screen by pressing
the (END) button twice (for function menu screen, press the
(END) button once).
Model Copy "M-COP"
"GROUP" mode
"SW/DIAL COPY" mode
Setup item selection
- Select by (JOG) button up or
down operation.
Model number selection
- Use the (+) and (-) buttons to
make adjustments.
Model No.
M1~M40
Copy execution button
- (+) and (-) buttons pressed
simultaneously for about 1 sec-
ond.
111