Cps-1 Mixing "Cps Mix - FUTABA 4PK-2.4G SuperR Instruction Manual

This function controls the Futaba CPS-1 channel power switch.
Normally, when using the CPS-1 unit to light the vehicle dress-up and other illumination
(LED) the CPS-1 unit with LED connected is connected to a vacant switch channel and
the LED are turned on and off by switch while the vehicle is running. However, when
the CPS-1 mixing (CPS MIX) function is used the LED can be turned on and off and
flashed in step with steering and throttle operation, as well as being turned on and off
by switch. The flashing speed (cycle) can also be set.
For instance, the LED can be flashed as a brake light by throttle brake side operation.
Setting Special mixings
When 4th CH was set to ACT at Brake Mixing (p.74) or Dual ESC Mixing (p.90) is
used, CPS-1 Mixing cannot be used.
Press t
CPS-1 mixing adjustment
(Preparation)
・Connect the CPS-1 to the 4th CH of the receiver.
・When the LED are turned on and off by switch use the
function select switch function (P96) to set the switch to be
used.
94

CPS-1 Mixing "CPS MIX"

he button
The display is different depending on
the type selected with MODE. The fig-
ure shown below is for the SW SEL.
Special Mixes "S-MIX" (CPS MIX)
•Select the setting item by
button
* blinks at the current setup
item.