FUTABA 4PK-2.4G SuperR Instruction Manual page 89

4WS mixing adjustment
(Preparation)
Since this function is used by switching the type of 4WS with
a switch, the switch used by the function select switch func-
tion (p.96) is set.
1
(4WS type selection)
Operate the (JOG) button up and down and select the set-
ting item "MODE". Select the type by pressing the (+) or (-)
button.
"OFF" :Function OFF (front only)
"2TYP" :Front side only, reverse phase switching
"3TYP" :Front side only, reverse phase and same phase switching
"4TYP" :Front side only, reverse phase, same phase, and rear side only switching
Switched in the order shown in the figure below by set SW
"2TYP"：Front side only and reverse phase switching
"3TYP"：Front side only, reverse phase, and same phase switching
"4TYP"：Front side only, reverse phase, same phase, and rear side only switching
2
(Rear side travel adjustment)
Operate the (JOG) button up and down and select setting
item "RATE". Adjust the rear side travel with the (+) or (-) but-
ton.
3
(Mix mode setting)
Operate the (JOG) button up and down and select the setting
item "MXMD". Set the mix mode with the (+) or (-) button.
"OFF" :The EXP function of the 1st CH and other settings are not mixed.
"MIX" :The EXP function o the 1st CH and other settings are mixed.
4
To end setting, return to the opening screen by pressing the
(END) button three times (for direct selection, press the (END)
button once)
Dial / Trim Setting
The mixing amount can be adjusted by using the function dial function (p.98).
Special Mixes "S-MIX" (4WS MIX)
Function ON/OFF (MODE)
OFF, 2TYP, 3TYP, 4TYP
Rear rate (RATE)
0 ~ 100
Initial value:100
Mixing mode (MXMD)
OFF, MIX
Initial value: OFF
89