Throttle Lever - Can-Am Outlander 400 EFI 2009 Operator's Manual

Detach throttle body side cover from
throttle body.
vmo2008-019-054_a
LH SIDE OF ENGINE
1. Throttle cable
2. Side cover
3. Remove screw
4. Release cover clip
Insert the needle of the lubricant can in
the end of throttle cable adjuster.
WARNING
Always wear eye protection and
gloves when you lubricate a cable.
TYPICAL
NOTE: Place a rag around the throttle
cable adjuster to prevent the lubricant
from splashing.
Add lubricant until it runs out at throttle
body end of the throttle cable.
Reinstall and adjust the cable.

Throttle Lever

Throttle Lever Adjustment
Slide rubber protector back to expose
throttle cable adjuster.
Loosen lock nut then turn the adjuster
to obtain correct throttle lever free play.
NOTE: Measure throttle free play at
the tip of throttle lever.
Tighten lock nut and reinstall protector.
_______________
MAINTENANCE PROCEDURES
97