Radiator - Can-Am Outlander 400 EFI 2009 Operator's Manual

MAINTENANCE PROCEDURES
1. Oil filter screws
2. Oil filter cover
3. O-ring
4. Oil filter
Check the cover O-ring and change it if
necessary.
Check and clean the oil filter inlet and
outlet area for dirt and other contami-
nations.
1. Inlet bore from the oil pump to the oil filter
2. Outlet bore to the engine oil providing
system
Wipe out any oil spillage on engine.
Apply engine oil on rubber seal of new
oil filter to ensure proper installation.
Install oil filter.
Install O-ring on oil filter cover.
______________
90
1. O-ring in place
Screw oil filter cover in place.
Torque screws to 10 N•m (89 lbf•in).
Change gasket ring on oil drain plug.
Clean gasket ring area on engine and oil
drain plug then reinstall plug.
Torque plug to 30 N•m (22 lbf•ft).
Refill engine at the proper level with
the recommended oil. Refer to
IFICATIONS
for capacity.
Start engine and let idle for a few min-
utes. Ensure oil filter and oil drain plug
areas are not leaking.
Stop engine.
Wait a while to allow oil to flow down to
crankcase then check oil level. Refill as
necessary.
Dispose of oil as per your local environ-
mental regulations.

Radiator

Radiator Inspection
Periodically check the radiator area for
cleanliness.
SPEC-