Throttle Lever; 2Wd/4Wd Selector - Can-Am Outlander X mr Series Operator's Manual

1) Throttle Lever

The throttle lever is located on the RH
side of the handlebar.
When pushed forward, it increases the
engine speed and allows engagement
of the transmission on the selected
range.
When released, the engine speed
should automatically return to idle and
the vehicle will gradually slow down.
V07I01Y
TYPICAL
1. Throttle lever
2. To accelerate
3. To decelerate

2) 2WD/4WD Selector

The 2WD/4WD selector is located on
the RH side of the handlebar.
This selector allows to choose be-
tween 2WD and 4WD when the ve-
hicle is stopped.
While reading this Operator's Guide, remember that:
Indicates a potential hazard that, if not avoided, could result in serious
injury or death.
2
3
1
WARNING
_______________
CONTROLS/INSTRUMENTS/EQUIPMENT
vmo2008-019-005_b
TYPICAL
1. Selector
2. 2WD position
3. 4WD position
NOTICE
The
stopped to engage or disengage
2WD/4WD selector.
damage may occur if selector is en-
gaged or disengaged while driving.
NOTICE
If the rear wheels are
spinning, release the throttle and
wait engine return to the idle before
selecting the 4WD mode.
The 4WD mode is engaged when the
selector is pushed downwards.
vehicle must
Mechanical
be
73