Installing A Half-Height Fld - Silicon Graphics POWER CHALLENGE User Manual

Installing a Half-Height FLD

The drive must be properly mounted on a drive sled and configured for a
channel and operating protocol (single-ended or differential). See Figure 4-3.
Follow these instructions to install a half-height front-loading device:
1. If your drive did not come already mounted on a sled, place it on top,
as shown in Figure 4-3. Be sure the EMI shield is affixed to the bottom
of the drive and is aligned as shown in the drawing.
If your drive did not come with an EMI shield, installation of the
Note:
part is not necessary.
2. Secure the drive to the bottom of the sled with the four screws
provided.
3. Plug the drive-to-adapter cable into the proper channel connector.
4. Orient the FLD and sled assembly so that the connectors on the back are
on the bottom half of the drive and face away from you.
5. Carefully insert the device into the drive bay until it seats firmly into
the lever catch and the locking lever has moved all the way to the right.
Installing and Configuring Additional FLDs
47