Fuji Xerox DocuCentre-IV C2260 User Manual page 137

Offset Stacking
This option is displayed when you select [Center Tray - Lower] for the output
destination. When an optional finisher is installed, this option is displayed when you
select [Right Middle Tray].
The offset is a function for slightly offsetting and outputting each paper stack to allow
you to distinguish the separations. You can select from [Offset per Set], [Offset per
Job], [Offset Every N Pages], [Offset Every N Sets], and [System Default].
Note • This feature does not appear for some models. An optional component is required. For more
• If you select [System Default], the setting in the System Administration mode will be
Paper Size and Stapling Position
Finisher-A1
,
A4 B5 ,
7.25 x 10.5" ,
8.5 x 11"
16K
A4, A3, B4,
8.5 x 11",
,
8.5 x 13"
8.5 x 14",
11 x 17", 8K
Finisher-B1
,
A4 B5 ,
7.25 x 10.5" ,
,
8 x 10"
8.5 x 11"
16K
A4, A3, B4,
8.5 x 11",
,
8.5 x 13"
8.5 x 14",
11 x 15",
11 x 17", 8K
* : The staple orientation displayed on the touch screen differs from the actual staple orientation. Outputs are stapled
in the orientation shown in the above table.
information, contact our Customer Support Center.
effective. For information on how to change the setting, refer to "5 Tools" > "Copy Service
Settings" > "Copy Defaults" > "Output Destination" in the Administrator Guide.
1 Staple 1 Staple
(Left) (Right)
,
1 Staple 1 Staple
(Left) (Right)
*
,
*
2 Staples 2 Staples
(Left)
*
*
Output Format
2 Staples
(Top) (Right)
135
3