APRILIA SL 750 SHIVER Service Station Manual page 55

SL 750 SHIVER
•
11 - REPLACE THE MAIN INJECTOR RELAY (POLARISED) 41 - END
•
12 - CHECK IF THERE IS VOLTAGE ON THE ORANGE/RED CABLE OF THE AUXILIARY
INJECTION RELAY (POLARISED) 42.
•
13 - CHECK IF THERE IS VOLTAGE ON THE YELLOW/PURPLE CABLE.
•
14 - RESTORE THE CABLE HARNESS - END
•
15 - SET THE KEY TO "OFF" AND THEN "ON": DOES THE VOLTAGE ON THE YELLOW/
PURPLE CABLE REACH APPROX. 1-2V FOR 2 SECONDS?
•
16 - REPLACE THE AUXILIARY INJECTOR RELAY (POLARISED) 42 - END
•
17 - WHEN THE KEY IS TURNED TO "OFF", CHECK CONTINUITY AND GROUND IN-
SULATION OF THE RED/BROWN CABLE FROM THE AUXILIARY INJECTION RELAY 42
TO THE FUEL PUMP CONNECTOR.
•
18 - WHEN THE KEY IS TURNED TO "OFF", CHECK CONTINUITY AND GROUND IN-
SULATION OF THE YELLOW/PURPLE CABLE FROM THE RELAY TO PIN 62, VEHICLE
CONNECTOR.
•
19 - RESTORE THE CABLE HARNESS.
•
20 - CHECK THERE IS GROUND INSULATION FOR THE BLUE CABLE OF THE PUMP
CONNECTOR.
•
21 - RESTORE THE CABLE HARNESS - END
•
22 - CHECK THE VEHICLE CONNECTOR.
•
23 - RESTORE THE CABLE HARNESS - END
•
24 - CHECK IF THE PUMP RESISTANCE IS APPROX. 1 OHM. REPLACE THE PUMP IF
THE RESISTANCE VALUE IS NOT THAT SPECIFIED - END
•
25 - REPLACE THE CONTROL UNIT - END
•
26 - RESTORE THE CABLE HARNESS - END
•
27 - DOES THE MOTOR TURN WHEN THE STARTER BUTTON IS PRESSED?
•
28 - WHAT DOES THE "START-UP ENABLING SWITCH" STATUS ON AXONE (DEVICE
STATUS/ICON "0/1" SCREEN PAGE) MEAN?
YES, go to 13; OK, go to 14
OK, go to 15; NOT OK, go to 16
YES, go to 17; NO, go to 18
YES, go to 20; NO, go to 19
YES, go to 22; NO, go to 21
OK, go to 24; NOT OK, go to 23
OK, go to 25; NOT OK, go to 26
YES, go to 29; NO, go to 28
YES, go to 43; NO, go to 64
Troubleshooting
TROUBL - 5